RGBW.ino

 
 
#include <FastLED.h>
 
// How many leds in your strip?
#define NUM_LEDS 10
 
// For led chips like WS2812, which have a data line, ground, and power, you just
// need to define DATA_PIN.  For led chipsets that are SPI based (four wires - data, clock,
// ground, and power), like the LPD8806 define both DATA_PIN and CLOCK_PIN
// Clock pin only needed for SPI based chipsets when not using hardware SPI
#define DATA_PIN 3
 
// Define the array of leds
CRGB leds[NUM_LEDS];
 
// Time scaling factors for each component
#define TIME_FACTOR_HUE 60
#define TIME_FACTOR_SAT 100
#define TIME_FACTOR_VAL 100
 
void setup() {
    Serial.begin(115200);
    FastLED.addLeds<WS2812, DATA_PIN, GRB>(leds, NUM_LEDS).setRgbw(RgbwDefault());
    FastLED.setBrightness(128);  // Set global brightness to 50%
    delay(2000);  // If something ever goes wrong this delay will allow upload.
}
 
void loop() {
    uint32_t ms = millis();
    
    for(int i = 0; i < NUM_LEDS; i++) {
        // Use different noise functions for each LED and each color component
        uint8_t hue = inoise16(ms * TIME_FACTOR_HUE, i * 1000, 0) >> 8;
        uint8_t sat = inoise16(ms * TIME_FACTOR_SAT, i * 2000, 1000) >> 8;
        uint8_t val = inoise16(ms * TIME_FACTOR_VAL, i * 3000, 2000) >> 8;
        
        // Map the noise to full range for saturation and value
        sat = map(sat, 0, 255, 30, 255);
        val = map(val, 0, 255, 100, 255);
        
        leds[i] = CHSV(hue, sat, val);
    }
 
    FastLED.show();
    
    // Small delay to control the overall speed of the animation
    //FastLED.delay(1);
 
}