writeUCS7604()

void fl::anonymous_namespace{channel.cpp.hpp}::writeUCS7604	(	fl::vector_psram< u8 > *	data,
		PixelIterator &	pixelIterator,
		ClocklessEncoder	encoder,
		const ChannelOptions &	settings,
		EOrder	rgbOrder,
		bool	managed )

Encode UCS7604 pixel data into the channel data buffer.

Parameters

data	Output byte vector (cleared by caller)
pixelIterator	Pixel iterator with color order and RGBW conversion
encoder	ClocklessEncoder value identifying the UCS7604 mode
settings	Channel settings (for gamma override)
rgbOrder	RGB ordering for current control reordering

Definition at line 552 of file channel.cpp.hpp.

                                                              {
    // Map encoder enum to UCS7604Mode
    UCS7604Mode mode;
    switch (encoder) {
        case ClocklessEncoder::CLOCKLESS_ENCODER_UCS7604_8BIT:
            mode = UCS7604Mode::UCS7604_MODE_8BIT_800KHZ;
            break;
        case ClocklessEncoder::CLOCKLESS_ENCODER_UCS7604_16BIT:
            mode = UCS7604Mode::UCS7604_MODE_16BIT_800KHZ;
            break;
        case ClocklessEncoder::CLOCKLESS_ENCODER_UCS7604_16BIT_1600:
            mode = UCS7604Mode::UCS7604_MODE_16BIT_1600KHZ;
            break;
        default:
            // Should never happen — caller already checked
            mode = UCS7604Mode::UCS7604_MODE_16BIT_800KHZ;
            break;
    }
 
    // Get current control from global UCS7604 brightness
    UCS7604CurrentControl current = ucs7604::brightness();
 
    // Reorder current control values to match wire order (same logic as UCS7604ControllerT)
    u8 rgb_currents[3] = {current.r, current.g, current.b};
    u8 pos0 = (static_cast<int>(rgbOrder) >> 6) & 0x3;
    u8 pos1 = (static_cast<int>(rgbOrder) >> 3) & 0x3;
    u8 pos2 = (static_cast<int>(rgbOrder) >> 0) & 0x3;
    UCS7604CurrentControl wire_current(
        rgb_currents[pos0], rgb_currents[pos1], rgb_currents[pos2], current.w);
 
    // Get gamma LUT.
    //
    // Only the unbound path uses it. With a profile bound the pixel source
    // has already produced the device drive and quantized it once, to 16
    // bits, so widening it again through a curve is the second shaping stage
    // B1 and section 6 forbid after the device solve -- and the 2.8 here is
    // `value_or`'s default rather than anything the caller asked for, since
    // `setColorProfile` clears `mGamma`. #4326.
    // The iterator's own state, not the options'. `hasColorProfile()` says a
    // profile is configured; it does not say the managed iterator was built.
    // A rejected binding leaves the legacy controller in place, and taking
    // the no-gamma path over its 8-bit pixels would drop a stage that path
    // still needs.
    const bool wide_source = managed;
    float gamma = settings.mGamma.value_or(2.8f);
    fl::shared_ptr<const Gamma8> gamma8 = Gamma8::getOrCreate(gamma);
 
    bool is_rgbw = pixelIterator.get_rgbw().active();
    size_t num_leds = pixelIterator.size();
 
    // (#2558) UCS7604 is a 4-channel chipset (always RGBW). If the user
    // configured this channel for 5-channel RGBWW (warm-W + cool-W), the
    // chipset can't carry the second W byte. Warn loudly — silently dropping
    // the white channels would be very hard to diagnose. The pixel iterator
    // continues to emit RGB-only bytes (is_rgbw=false) so the strip still
    // lights up, just without the W diode.
    if (pixelIterator.get_rgbww().active() && !is_rgbw) {
        FL_WARN_ONCE("UCS7604 cannot carry 5-channel RGBWW — this chipset "
                     "always emits 4-channel RGBW. The warm/cool white "
                     "channels in your Rgbww config will be dropped. "
                     "Set ChannelOptions.mWhiteCfg = Rgbw{...} instead to "
                     "silence this warning.");
    }
 
    // Encode into the data buffer
    encodeUCS7604(pixelIterator, num_leds, fl::back_inserter(*data),
                  mode, wire_current, is_rgbw, gamma8.get(), wide_source);
}

References fl::UCS7604CurrentControl::b, fl::back_inserter(), fl::ucs7604::brightness(), fl::CLOCKLESS_ENCODER_UCS7604_16BIT, fl::CLOCKLESS_ENCODER_UCS7604_16BIT_1600, fl::CLOCKLESS_ENCODER_UCS7604_8BIT, fl::encodeUCS7604(), fl::FL_NO_EXCEPT, FL_WARN_ONCE, fl::UCS7604CurrentControl::g, fl::gamma(), fl::shared_ptr< T >::get(), fl::Gamma8::getOrCreate(), fl::UCS7604CurrentControl::r, fl::UCS7604_MODE_16BIT_1600KHZ, fl::UCS7604_MODE_16BIT_800KHZ, fl::UCS7604_MODE_8BIT_800KHZ, fl::UCS7604CurrentControl::w, and writeUCS7604().

Referenced by writeUCS7604().

Here is the call graph for this function:

Here is the caller graph for this function: